Washing machine repair in San Diego.
Top-load, front-load, high-efficiency, stackable — we repair them all. The three calls we get most: won't drain, won't spin, leaks water. Most are solved in a single visit with parts on the truck: drain pumps, door boots, shock absorbers, drive belts, and control boards for every major brand.
What's included in this service?
- Drain pump and hose diagnosis and replacement
- Door boot (front-loader) replacement with leak testing
- Drive belt, motor coupling, and transmission service
- Shock absorber and suspension rod replacement for walking washers
- Inlet valve, water-level switch, and pressure sensor testing
- Control board and user-interface repair
- Bearing and tub seal replacement on qualifying units
- Front-loader mildew cleanup and gasket replacement
When do you need this service?
- Water stays in the drum after the cycle ends
- Washer walks across the floor or shakes violently on spin
- Leaking from the front, bottom, or detergent drawer
- Stops mid-cycle with an error code
- Clothes still soaked after the spin cycle
- Loud grinding or clunking during spin
- Smells musty even after a hot wash
What do homeowners ask about Washer Repair?
How much does washing machine repair cost?
Diagnostic is $89 (credited to the repair). The three most common fixes — drain pump, door boot, drive belt — run $180 to $320 parts and labor. Control boards and bearings are higher. We give you a flat-rate quote before starting.
Is a bearing replacement worth it?
On most mid-range front-loaders, bearing replacement runs $550–$800 and makes sense only if the washer is under 6 years old. On high-end brands (Miele, Speed Queen, commercial LG) it always makes sense. We quote both repair and replacement so you can see the tradeoff.
My front-loader smells bad. Can you fix that?
Yes. The standard fix is a gasket clean-and-treat, followed by a diagnosis of whether the door boot is retaining water behind the fold. In older units we sometimes replace the boot and run a tub-clean cycle to reset the baseline.
Do you work on stackable units?
Yes. Stackables are slightly trickier because access is limited, but we carry extra-long hoses and tools designed for compact laundry closets. Most stackable repairs complete in a single visit.
Can you repair a commercial-coin washer?
Our commercial appliance repair covers coin-ops and commercial-grade laundry in apartments, laundromats, and property-managed buildings. See the commercial page for details and contract options.
Where do we offer Washer Repair in San Diego County?
We provide washer repair in every city and community in San Diego County. Pick your city for local climate notes and service specifics.
See washer repair in all 47 cities
Homeowners who hired us for this
Our freezer died on a Thursday morning with a full load of meat. Called at 9, they were at the house by 1, diagnosed a failed evaporator fan, and had it fixed in under an hour. Flat-rate quote up front, no upsell.
Front-loader kept stopping mid-cycle with an error code. Previous company wanted to replace the entire control board for $650. Repair Pro diagnosed a $180 drain pump and a partial clog. Working perfect again.
Dryer took two cycles to finish every load. Tech walked in, knew immediately to check the vent line, cleaned 15 feet of lint out of the wall run. Saved me from buying a new dryer. Also spotted a brittle vent hose and replaced it.
Need washer repair in San Diego County?
Call for a free quote. Most work scheduled within the week.