Oven, range, and cooktop repair.
Gas or electric, slide-in or free-standing, induction or radiant — we repair them all. The failures we see most: bake element, oven igniter, control board, surface burner switch. We arrive with the parts on the truck and the manometer and multimeter to prove the fix works before we leave.
What's included in this service?
- Bake and broil element replacement (electric ovens)
- Oven igniter, flame sensor, and safety valve service (gas ovens)
- Surface burner element, switch, and infinite control repair
- Induction coil and generator board diagnosis
- Control board, touch panel, and clock/timer repair
- Door hinge, seal, and glass replacement
- Self-clean thermal fuse and latch service
- Gas line leak test and pressure verification
When do you need this service?
- Oven won't heat or won't reach set temperature
- One or more surface burners dead on an electric cooktop
- Gas igniter clicks but burner never lights
- Oven light doesn't come on or door won't latch
- Error code on the control panel
- Self-clean cycle won't start or gets stuck
- Smell of gas anywhere near the appliance (this is an emergency — shut off gas and call)
What do homeowners ask about Oven Repair?
How much does oven repair cost?
Diagnostic is $89 and applies to the repair. The most common fixes — bake element, igniter, door hinge, surface switch — run $180 to $360. Control boards are $350 to $600 depending on brand. You get a flat-rate quote before we start.
My oven turns on but won't get hot enough. Why?
On electric ovens it's usually the bake element or the temperature sensor. On gas, it's almost always the igniter — they weaken with age and can still glow but not draw enough current to open the gas valve. Both repairs are under $300 in most cases.
Do you repair high-end brands like Wolf and Viking?
Yes. We service Wolf, Viking, Thermador, Miele, Bertazzoni, La Cornue, and other high-end European lines. Parts can take 2–5 days to arrive from distributors on the less-common brands; we schedule the return visit when parts confirm.
Is it safe to use the oven while waiting for repair?
If you smell gas, don't use it — shut off the gas and call us immediately. If one burner is out but others work fine, the rest of the cooktop is safe. If the control board is fritzing (random error codes, erratic behavior), turn off the breaker until we arrive.
Do you work on induction cooktops?
Yes. Induction generator boards, coil assemblies, and touch controls are all part of what we repair. Parts tend to run higher on induction than on standard electric, but the repair is straightforward on most brands.
Where do we offer Oven Repair in San Diego County?
We provide oven repair in every city and community in San Diego County. Pick your city for local climate notes and service specifics.
See oven repair in all 47 cities
Homeowners who hired us for this
Our freezer died on a Thursday morning with a full load of meat. Called at 9, they were at the house by 1, diagnosed a failed evaporator fan, and had it fixed in under an hour. Flat-rate quote up front, no upsell.
Front-loader kept stopping mid-cycle with an error code. Previous company wanted to replace the entire control board for $650. Repair Pro diagnosed a $180 drain pump and a partial clog. Working perfect again.
Dryer took two cycles to finish every load. Tech walked in, knew immediately to check the vent line, cleaned 15 feet of lint out of the wall run. Saved me from buying a new dryer. Also spotted a brittle vent hose and replaced it.
Need oven repair in San Diego County?
Call for a free quote. Most work scheduled within the week.