Garbage disposal repair and replacement.
Humming but not spinning? Jammed with a bone or a peach pit? Leaking under the sink? We repair and replace every major brand — InSinkErator, Waste King, KitchenAid, Moen. Most calls resolve in under an hour with a replacement unit stocked on the truck if yours is beyond repair.
What's included in this service?
- Jam clearing and reset on any brand
- Flywheel, shredder ring, and impeller inspection
- Bearing and seal service where repairable
- Full disposal replacement with same or upgraded unit
- Dishwasher drain connection and air gap rerouting
- Sink-flange leak diagnosis and reseal
- Switch, outlet, and wiring diagnosis
- Stainless and batch-feed upgrade installation
When do you need this service?
- Disposal hums but doesn't spin
- No sound at all when switched on
- Leaking from the top (sink flange) or bottom (housing)
- Water drains slowly through the disposal
- Metal grinding sound (foreign object or bearing)
- Disposal trips reset button repeatedly
- Bad smell that scrub-and-ice won't fix
What do homeowners ask about Disposal Repair?
Is my disposal repairable or does it need replacement?
Jams, tripped resets, and switch issues are almost always repairable. Leaks from the housing (not the flange) usually mean replacement — the housing is the body and can't be resealed. Units over 10 years old with any major failure are usually better to replace than repair.
How much does a new disposal cost installed?
Most replacements run $320–$520 installed, depending on the brand you choose. InSinkErator Evolution Compact is our most common mid-range recommendation at around $420 installed. Waste King is a budget option; Pro series units are premium.
Can you install a disposal with a dishwasher hookup?
Yes — every disposal install includes the dishwasher drain connection. On new installs, we knock out the dishwasher plug on the new unit so the dishwasher drains properly (missing this is the #1 cause of dishwasher backups after a new disposal install).
My disposal just hums when I turn it on. What's wrong?
Almost always a jam. There's a hex key slot on the bottom of most units — insert the key, work it back and forth until the flywheel breaks free, press the red reset button on the bottom, and try again. If it's still humming, call us — you might have a seized motor.
Do you handle leaking sink flanges?
Yes. A leaking top (where the disposal mounts into the sink) usually means the plumber's putty has dried out or the mount was never tightened properly. We unmount, reseat with fresh sealant, and test. Under $200 in most cases.
Where do we offer Disposal Repair in San Diego County?
We provide disposal repair in every city and community in San Diego County. Pick your city for local climate notes and service specifics.
See disposal repair in all 47 cities
Homeowners who hired us for this
Our freezer died on a Thursday morning with a full load of meat. Called at 9, they were at the house by 1, diagnosed a failed evaporator fan, and had it fixed in under an hour. Flat-rate quote up front, no upsell.
Front-loader kept stopping mid-cycle with an error code. Previous company wanted to replace the entire control board for $650. Repair Pro diagnosed a $180 drain pump and a partial clog. Working perfect again.
Dryer took two cycles to finish every load. Tech walked in, knew immediately to check the vent line, cleaned 15 feet of lint out of the wall run. Saved me from buying a new dryer. Also spotted a brittle vent hose and replaced it.
Need disposal repair in San Diego County?
Call for a free quote. Most work scheduled within the week.